When an OptiFlow Inspector alert occurs, it means that the OptiFlow Inspector tool has detected a programming issue that can prevent one or more stations from irrigating.

Possible Causes:

• Points of connections have not been configured
  
  
• An active station may not be assigned to a pipe
  
  
• A station that is assigned to a pipe is not active
  
  
• A station that is assigned to a pipe does not have an assigned flow rate
  
  
• The site’s hydraulic tree is not providing sufficient flow to all stations
  
  
• The controllers do not have the same time zone setting as the site
  
  
• The water windows do not occur within the site’s irrigation window
  
  
• The controller is not running the latest firmware

Possible Fixes:

• Review the alert details on the OptiFlow page and address the listed issues

Clearing an OptiFlow Inspector Alert

After resolving the issue(s) you can run the OptiFlow Inspector tool from the OptiFlow configuration page. The alert should clear, and you will see a green checkmark next to the listed item as shown in the example below.