Call Us 800.362.8774 Call Us 866-294-5847 Contact Training Training Training WeatherTRAK Login WaterCompass Login AppManager Login


    Single, Two and Four Station biCoder Installation Guide

    BL-5201/5202/5204 biCoder

    PDF es:

    Installation Instructions 

    1.  Power off the two-wire when installing devices. Leave 24 to 36 inches of slack on the two-wire to allow for easy installation and maintenance.

    2.  Place the biCoder in the valve box for convenience and protection. Valves can be located a maximum of 150ft from the biCoder location by using additional 14 gauge wires.

    3.  Wire the valves according to the wiring diagram label on the back of each biCoder.

    4.  Connect the red and black wire from the biCoder to the corresponding red and black wires on the two-wire using 3M™ DBR/Y-6 or equivalent connectors. It is critical that polarity be maintained.

    5.  Using the controller, test the connections and assign the biCoder addresses as instructed in the controller’s user manual.


    The common wires cannot be shared between different biCoders.