1. Make sure that the irrigation controller you want to work with is displayed in the BaseManager footer. To select a different controller, click the Menu icon in the upper-left corner of the BaseManager page, and then click Sites and Controllers. Select the desired controller.
2. Position the cursor on the Devices tab, and then click the type of device that you want to test.
3. On the device page, find the row for the specific device that you want to test, and then click the Test icon . The test results display in a pop-up box.
4. When you have finished viewing the test results, click the Cancel  button to close the pop-up box.

1. Select the desired controller by selecting BaseManager then selecting Menu and Sites and Controllers
2. Once you have your controller selected, go to Quick View
   1. select the zone you would like to test

1. Select the desired controller by selecting BaseManager then selecting Menu and Sites and Controllers
2. Once you have your controller selected, in Maps you will select current controller

3. Find one of the zone markers on the map and click on it
   1. This is where you can Test the zone

1. Select the desired controller by selecting BaseManager then selecting Menu and Sites and Controllers.
2. Once you have your controller selected, in Live View you will select Self Test.

3. From this menu you can test a single Two-Wire device or All of the Two-Wire devices on the Two-Wire
   1. Select Enter on the test you would like to complete

Test Single Two-Wire Device 
Is a diagnostic operation on Baseline controllers used to verify communication and functionality of a specific decoder. It measures current, voltage, and voltage drop.

Check Two-Wire Addresses 
Is a diagnostic test functionality available on BaseManager and at the controllers. It tests each two-wire device and fixes addressing problems by ensuring the zone number and serial number match.

Test All Two-Wire Devices 
The controller will test all decoders on the local two-wire and any connected SubStations. Once finished, a summary screen will display status counts for each device type, and detailed results will be posted to a report viewable in the Reports dial position. Any devices with errors will generate an entry in the Messages list.

Two-Wire Blink Test 
Is a diagnostic tool used to identify bad electrical connections, broken wires, or device failures by sending a command that causes the LED on each decoder to blink.

1. Select the desired controller by selecting BaseManager then selecting Menu and Sites and Controllers.
2. Select Test
   1. This is where you can test the following:
      1. Test Zone
      2. Test MV/Pump
      3. Test Moisture Sensor
      4. Test Flow Sensor
      5. Test Event Switch
      6. Test Temp. Sensor
      7. Test Alert Relay
      8. Test Two-Wire
      9. Test All devices