Step-by-Step Guide

Manually Running a Single Zone

1. Press the Manual Run button on the controller.

2. Navigate to and open the menu named Manual Start or Stop Zone. Note that the option for running all zones may be better suited within a program, which is covered in the next section.

3. Press OK to open the menu.

4. Before selecting a zone, decide if you want to change the default runtime. If you need to adjust it, set your desired runtime (for example, 4 minutes). Be aware that the time is settable for hours, minutes, and seconds—make sure you don't accidentally set a zone to run for hours when you intended just minutes.

5. Navigate back to Select Zone and press OK.

6. Look for and select the zone you want to manually run using the arrow keys, then press OK to start the zone for the designated runtime.

Manually Running an Existing Program

1. Press the Manual Run button on the controller.

2. Navigate to and open the menu named Start or Stop Program. This is the simplest option for running programs. Note that there are other program options available once you start using BaseManager, but using Start or Stop Program is the most straightforward method.

3. With the Start or Stop Program menu open, use the arrow keys to navigate to the program you want to run.

4. Select the desired program and press OK.

5. Back on the run screen, the zones that are in the selected program are ready to run. If the program only allows one zone to run at a time, the first zone will start while the other zones wait their turn. As each zone completes, the next zone will take its turn until the entire program is complete.

Video Walkthrough

Video originally published May 2022.

If you have questions, here are 3 ways to get answers:

1. Search within this HydroPoint knowledgebase

2. Visit the HydroPoint support page

3. Call 800-362-8774 or email support@hydropoint.com, hours are Mon-Fri 3:00 AM – 6:00 PM PT and Sat 9:00 AM – 2:00 PM PT.