Call Us 800.362.8774 Call Us 866-294-5847 Contact Training Training Training WeatherTRAK Login WaterCompass Login AppManager Login

Knowledgebase

    Updating Details for Control Point Devices

    FlowStation App: Working with Control Point Settings

    PDF es:

    You can update the details for the flow meter, master valve, and/or pressure sensor that are assigned to a control point.

    1.  On the main FlowStation App page, click the FlowStation where the control point that you want to work with is assigned. The slide-out pane displays.

    2.  Scroll down to the section where the control point that you want to work with is shown. If necessary, click the header rows to expand the sections.

    3.  Click the control point that you want to work with. The Control Point information pane displays.

    4.  Click Edit in the lower-right corner. The control point details are available for editing.

    5.  If necessary, click the Flow Devices header to expand the section.

    6.  Find the row for the device that you want to update.

    7.  In the Description field, type a description that identifies the device.

    Note

    Limit the number of characters in the Description to 42 characters. If you enter a longer description, the controller will automatically shorten it, and then pass the new version back to PipeView.


    8.  Click in the Enabled field to add or remove the check mark. When a check mark displays in the field, the device is enabled. When the field is empty, the device is disabled and will not be used.

    9.  Update the specific information for any of the following devices:

    Flow Meter

    K Value: Click the up or down arrows in the field to enter the calibration factor for the flow device that this flow biCoder is connected to.

    Master Valve

    Normally Open: Click in the field to add or remove the check mark. When a check mark displays in the field, the master valve is normally open. When the field is empty, the master valve is normally closed.

    Pressure Sensor

    Min Limit: Click the up or down arrows in the field to enter the minimum pressure reading for the connected pressure sensor.

    Max Limit: Click the up or down arrows in the field to enter the maximum pressure reading for the connected pressure sensor.


    10. Click Save in the lower-right corner.