Call Us 800.362.8774 Call Us 866-294-5847 Contact Training Training Training WeatherTRAK Login WaterCompass Login AppManager Login

Knowledgebase

    WeatherTRAK Smart Controllers H2O 2-Wire Components Programming Decoders

    Programming a Master Valve H2O 2-Wire Decoder

    For H2O 2-Wire controllers firmware version 8.9 and higher

    PDF
    These instructions are for H2O 2-Wire controllers running firmware version 8.9 (released August 2021) and higher.  To find your firmware version number, read: How Do I Find the Firmware Version on my Controller?

    1.  Press the SETUP button.

    2.  Press the à  button until the CONFIGURE H2O 2-WIRE page displays (Setup : 15)

    3.  Press the + or – buttons to select Program Decoder.


    4.  Press the SELECT button. You will be prompted to attach a decoder. Attach the decoder to the Station Decoder Program terminal. Be mindful of the RED and BLK terminal inputs.


    5.  Press the * button to start programming. The controller will now read the attached decoder.


    6.  Use + or – buttons to select MV1, MV2, MV3, or MV4

    7.  Press the * button to continue programming the decoder.

    8.  Next you will be asked to set the Power Level for the decoder. Use the + or – buttons to choose the appropriate power level for the decoder.

    The first underlined choice is Low and is the default power level. This is typically fine for most systems; however, Med and High are also available options. Some decoders may require more power due to a longer 2-wire path or a higher electrical requirement.

    9.  Press the * button to finish programming the decoder.

    10.  A PROGRAMMING SUCCESSFUL screen displays, noting the master valve number that the decoder was assigned to.


    11.  Unplug the decoder from the Station Decoder Program terminal and make sure to label.

    12.  Select New  > to continue programming additional decoders. Select < Done if finished.


    Related Articles